When properly assembled and set up your KMX will provide many years of enjoyment. KMX Karts Ltd does its utmost to design and produce safe and fun products and so the utmost care has been used to ensure that your KMX is strong, safe and durable.
3.0 Assembly Instructions Carefully lift all the items from the box and remove the protective packaging. Stand the box on its open end and place the trike frame on top. (Photo 1) FRONT WHEEL ASSEMBLY Take the left front wheel assembly. Insert the spacers and attach to the frame using the M10 bolt, nut, washers and plastic cap provided.
Page 4
Attach the pedals. Note the left pedal has a left hand thread. SEAT ATTACHMENT Slide the seat stays over the two seat stay adjuster rods attached to the rear of the frame. Insert an M6 bolt into the first threaded hole on each seat stay adjuster rod. (Photo 7) Position the seat on the frame and assemble the sliding seat clamp.
Do not allow your KMX to be pulled by any other vehicle. KMX Karts Ltd, the suppliers of the KMX and/or the manufacturer do not accept any liability for any injury or any other damage sustained and any incurred costs as a result of (wrongfully and/or impropriate) use of the KMX.
Every month or after your KMX gets wet. (In addition to above). Immediately after riding: Dry bike with towel; pedal the drive train with your hands while lifting the rear wheel to spin water out of rear bearing surfaces, cog set, chain, etc. Wash bike completely with soap and water.